Starting the massive garage clean and would love to get rid of these this weekend. I no longer need them since I bought a mill.
The small one I bought new 7 or 8 years ago and have only used it a few times. I'm looking for $50 out of it.
The larger one belonged to my father in law. It's ancient, heavy, and built tough. I've never used it and it's missing the belt guard, but I did power it up to make sure it spins. It also appears that you can rotate the head to drill at an angle since there is an angle gauge on it. Asking $75 for it.
Both have 1/2" chucks.
www.ColoradoClassicBroncos.com
A place for Coloradans to unite with our love of 66-77 Ford Broncos
Drill press.
4 posts
• Page 1 of 1
Drill press.
by EFI Guy » Thu May 12, 2016 7:21 pm
You do not have the required permissions to view the files attached to this post.
-
EFI Guy - VENDOR
- Posts: 442
- Joined: Sun Dec 15, 2013 7:22 pm
- Location: Arvada
Re: Drill press.
by Digger » Thu May 12, 2016 7:45 pm
EFI Guy wrote:Starting the massive garage clean and would love to get rid of these this weekend. I no longer need them since I bought a mill.
The small one I bought new 7 or 8 years ago and have only used it a few times. I'm looking for $50 out of it.
The larger one belonged to my father in law. It's ancient, heavy, and built tough. I've never used it and it's missing the belt guard, but I did power it up to make sure it spins. It also appears that you can rotate the head to drill at an angle since there is an angle gauge on it. Asking $75 for it.
Both have 1/2" chucks.
Don't need a drill press, but curious what mill you bought.
Cummins R2.8 diesel, ZF5, AtlasII, HP44/BB9, ARBs, coiled / linked suspension, 37" KO2s, full cage, bumpers, etc.
Build Thread: http://www.coloradoclassicbroncos.com/viewtopic.php?f=3&t=5420
Average 23.5 mpg, Best tank: 25.1 mpg
Build Thread: http://www.coloradoclassicbroncos.com/viewtopic.php?f=3&t=5420
Average 23.5 mpg, Best tank: 25.1 mpg
-
Digger - Official CCB Member
- Posts: 1276
- Joined: Fri Jun 21, 2013 7:53 pm
Re: Drill press.
by EFI Guy » Thu May 12, 2016 8:14 pm
I believe it's a Jet-16. Nothing fancy.
Sent from my SCH-I545 using Tapatalk
Sent from my SCH-I545 using Tapatalk
-
EFI Guy - VENDOR
- Posts: 442
- Joined: Sun Dec 15, 2013 7:22 pm
- Location: Arvada
Re: Drill press.
by plumbdoctor » Thu May 12, 2016 9:47 pm
I'm in for the small one
Your sh!* is my bread and butter!
-
plumbdoctor - Official CCB Member
- Posts: 568
- Images: 0
- Joined: Tue Oct 05, 2010 9:17 pm
- Location: Golden
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests