www.ColoradoClassicBroncos.com
A place for Coloradans to unite with our love of 66-77 Ford Broncos
Ball joint press?
5 posts
• Page 1 of 1
Ball joint press?
by akaFrankCastle » Mon Apr 20, 2015 9:17 pm
Anyone have one I can borrow? I figure I can knock out a few sets of axles in a weekend, including my Super Duty, if I can get my hands on the tool.
Stroppe'd
1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar.
The Terrible One
1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering.
1973 Stroppe Baja project
1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar.
The Terrible One
1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering.
1973 Stroppe Baja project
-
akaFrankCastle - Official CCB Member
- Posts: 4901
- Images: 0
- Joined: Wed Oct 27, 2010 5:25 pm
- Location: Colorado Springs
Re: Ball joint press?
by phyler » Mon Apr 20, 2015 9:23 pm
AutoZone loans them for free. I got a nice OTC one from them when I did mine. I put some pressure on it and thought it was a pretty nice unit. They also had different sleeves for different joints available too. Just a thought of no one has one near you.
1975 Ranger Edition that I've had longer than I've been without it.
- phyler
- CCB Admin
- Posts: 1202
- Joined: Sat Oct 02, 2010 8:41 pm
- Location: Erie
Re: Ball joint press?
by Dirtheadz » Tue Apr 21, 2015 6:22 am
I have one, come on over & pick it up
!!! Being original is a blueprint for followers !!!
-
Dirtheadz - Official CCB Member
- Posts: 929
- Joined: Thu Jan 27, 2011 8:27 pm
- Location: Colorad Springs
Re: Ball joint press?
by cravenbronco » Tue Apr 21, 2015 6:58 am
Dirtheadz wrote:I have one, come on over & pick it up
X2
- cravenbronco
- Official CCB Member
- Posts: 916
- Joined: Sat Apr 19, 2014 4:40 pm
- Location: Bailey
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests