www.ColoradoClassicBroncos.com
A place for Coloradans to unite with our love of 66-77 Ford Broncos
Measurement Needed
5 posts
• Page 1 of 1
Measurement Needed
by Justin » Sun Dec 13, 2020 5:58 pm
Would one of you be willing to measure from the interior floor to the highest point on the inside of the roof, ideally without a headliner? Trying to figure out if I can fit my Bronco in my garage with a hard top on it.
-
Justin - Official CCB Member
- Posts: 6198
- Images: 0
- Joined: Sat Oct 09, 2010 11:04 pm
- Location: Lakewood
Re: Measurement Needed
by phyler » Sun Dec 13, 2020 6:52 pm
From between the front two seats to the roof is 45.5".
Also, the top of roof is about 6" from the top of the door frame. I laid a straight edge across my roof to get that.
Sent from my Pixel 5 using Tapatalk
Also, the top of roof is about 6" from the top of the door frame. I laid a straight edge across my roof to get that.
Sent from my Pixel 5 using Tapatalk
1975 Ranger Edition that I've had longer than I've been without it.
- phyler
- CCB Admin
- Posts: 1202
- Joined: Sat Oct 02, 2010 8:41 pm
- Location: Erie
Re: Measurement Needed
by Jesus_man » Mon Jan 04, 2021 9:35 am
Ain't no shame in dropping PSI in the tires to get it to fit!! Just sucks if you have to do that daily.
1973 Bronco, 351 SEFI, Locked, discs, 35's ZF-5spd and Atlas 4spd. 235:1 Crawl Ratio. It may be ugly, but it's slow.
http://www.ucora.org
http://www.ucora.org
-
Jesus_man - Official CCB Member
- Posts: 5987
- Joined: Thu Nov 11, 2010 9:36 am
- Location: California
Re: Measurement Needed
by Justin » Mon Jan 04, 2021 11:38 am
I'm pretty much daily driving it at the moment, otherwise I'd consider it.
-
Justin - Official CCB Member
- Posts: 6198
- Images: 0
- Joined: Sat Oct 09, 2010 11:04 pm
- Location: Lakewood
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests