|
It is currently Fri Nov 22, 2024 1:26 pm
|
Author |
Message |
ZOSO
Moderator
Joined: Mon Nov 15, 2010 5:58 pm Posts: 3906 Location: Henderson, Co
|
Re: muffle that noise!!
my exhaust I just pulled off was all the way back against the bumper. turned and went out the side. was tucked up real close to the body up above the the bumper low point. I'll send you some pics since they are on my phone.
_________________ Rob
74 Ranger EFI351w, 4r70w, ARB 5.13 9in, ARB 5.13D44, and a bunch of other goodies. Best of all the family memories.
04 Mustang Cobra, KenneBell 2.2 feeding a lot of boost on E85. Tire shredding machine
New project: 77 Bronco Ranger, body work and more body work.
Very little left of a 72 durango tan explorer sport
|
Tue Jan 05, 2021 5:58 pm |
|
|
Gunnibronco
Official CCB Member
Joined: Mon Jan 03, 2011 6:07 pm Posts: 4074 Location: Gardnerville, NV
|
Re: muffle that noise!!
_________________ "America is at that awkward stage. It's too late to work within the system, but too early to shoot the bastards." – Claire Wolfe 74-AWB 98", ZF5, Atlas4, TGW HP1060 and HP1014 axles, ARBs, 37's, 3.5" lift-5.5" front coil springs, Tahoe rear springs, EFI 302, h-boost, York OBA, 4x4x2, custom dash & gauges 72 U15- Explorer Sport-Candyapple Red (1 of 141)
|
Tue Jan 05, 2021 8:19 pm |
|
|
TOOLMAN
Official CCB Member
Joined: Mon Feb 14, 2011 10:29 am Posts: 768 Location: The MHC
|
Re: muffle that noise!!
You do not have the required permissions to view the files attached to this post.
_________________ Wilma - 71 1/2 Wagon; 3 1/2" WH lift, 1" BL, NP435, Chebby disc front, WH twin stick D20, EFI 302, Cool hood scoop, mucho cancer; purchased in 1990.
|
Wed Jan 06, 2021 8:38 pm |
|
|
TOOLMAN
Official CCB Member
Joined: Mon Feb 14, 2011 10:29 am Posts: 768 Location: The MHC
|
Re: muffle that noise!!
I can do better pictures when I can get it out of the garage. Granted, I haven't done any really tough trails since I did it, but I haven't dinged it yet. I don't think Chris has either. And his has been like that for a lot longer. It kind of reminds me of the tucked dual exhaust of the big block '60s Galaxies...
_________________ Wilma - 71 1/2 Wagon; 3 1/2" WH lift, 1" BL, NP435, Chebby disc front, WH twin stick D20, EFI 302, Cool hood scoop, mucho cancer; purchased in 1990.
|
Wed Jan 06, 2021 8:53 pm |
|
|
Gunnibronco
Official CCB Member
Joined: Mon Jan 03, 2011 6:07 pm Posts: 4074 Location: Gardnerville, NV
|
Re: muffle that noise!!
Thanks, that is about where mine used to be. It might be my only option.
_________________ "America is at that awkward stage. It's too late to work within the system, but too early to shoot the bastards." – Claire Wolfe 74-AWB 98", ZF5, Atlas4, TGW HP1060 and HP1014 axles, ARBs, 37's, 3.5" lift-5.5" front coil springs, Tahoe rear springs, EFI 302, h-boost, York OBA, 4x4x2, custom dash & gauges 72 U15- Explorer Sport-Candyapple Red (1 of 141)
|
Wed Jan 06, 2021 11:20 pm |
|
|
Jesus_man
Official CCB Member
Joined: Thu Nov 11, 2010 10:36 am Posts: 5984 Location: California
|
Re: muffle that noise!!
Toolman, that is along the lines I was thinking, but I think they need to be even higher. I'll bet any trail rated 5 of 10 or higher will have a high potential of damaging that. But with a fuel tank that takes up all the space between the frame rails, it makes it tougher to route. There is, however, a third option:
_________________ 1973 Bronco, 351 SEFI, Locked, discs, 35's ZF-5spd and Atlas 4spd. 235:1 Crawl Ratio. It may be ugly, but it's slow. http://www.ucora.org
|
Thu Jan 07, 2021 9:44 am |
|
|
landshark
Official CCB Member
Joined: Fri Oct 14, 2011 12:16 am Posts: 3942 Location: Denver, Wash Park Area
|
Re: muffle that noise!!
Hers mine, obviously hasn’t been an issue as there are so many other things to smash before i hit the exhaust. It’s 3” I believe and not many issues with fumes if I keep both windows closed or open both when I run the enclosed top. Gets a little bad when I have one window open and enclosed top closed up.
_________________ 1976 Bronco "Green, Yellow, whatever", 1969 Bronco "Red", 1972 Bronco Stocker "Kind of Blue/Grayish"
|
Thu Jan 07, 2021 10:04 am |
|
|
ZOSO
Moderator
Joined: Mon Nov 15, 2010 5:58 pm Posts: 3906 Location: Henderson, Co
|
Re: muffle that noise!!
Well I finally finished my exhaust completely. Im happy overall with my muffler choice. Routing sucked around the 4 link. It is as loud cruising as it is at idle. I can actually hear the stereo now going down the highway. Muffler is a Flowtec warlock turbo muffler. https://www.youtube.com/watch?v=gqvLqUwLacw
_________________ Rob
74 Ranger EFI351w, 4r70w, ARB 5.13 9in, ARB 5.13D44, and a bunch of other goodies. Best of all the family memories.
04 Mustang Cobra, KenneBell 2.2 feeding a lot of boost on E85. Tire shredding machine
New project: 77 Bronco Ranger, body work and more body work.
Very little left of a 72 durango tan explorer sport
|
Sat Mar 13, 2021 8:50 am |
|
|
Justin
Official CCB Member
Joined: Sun Oct 10, 2010 12:04 am Posts: 6198 Images: 0 Location: Lakewood
|
Re: muffle that noise!!
Sounds good!
Sent from my SM-T810 using Tapatalk
|
Sun Mar 14, 2021 12:16 am |
|
|
Rox Crusher
Official CCB Member
Joined: Sun Oct 10, 2010 5:36 pm Posts: 3980 Location: Roxborough Park, Colorado
|
Re: muffle that noise!!
Looks and sounds good !
_________________ 1977 Sport, 351w OBDII EFI motor, 4R70W auto, 4:88 gears, ARB lockers, 3.5" suspension, 33" tires.
|
Sun Mar 14, 2021 2:59 pm |
|
|
Jesus_man
Official CCB Member
Joined: Thu Nov 11, 2010 10:36 am Posts: 5984 Location: California
|
Re: muffle that noise!!
That is a good noise! We need a drive-by video!
_________________ 1973 Bronco, 351 SEFI, Locked, discs, 35's ZF-5spd and Atlas 4spd. 235:1 Crawl Ratio. It may be ugly, but it's slow. http://www.ucora.org
|
Mon Mar 15, 2021 8:55 am |
|
|
|
Who is online |
Users browsing this forum: No registered users and 2 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|