|
|
Register •
FAQ
• Login
|
|
|
It is currently Fri Apr 26, 2024 1:07 pm
|
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
BOBS 2 68S
Official CCB Member
Joined: Sun Aug 04, 2013 2:19 pm
Posts: 375
Location: Hudson
|
 Pitman Arm nut I can not find the torque spec for the pitman arm nut. Does anyone know this?
|
| Sun Dec 31, 2017 5:38 pm |
|
|
|
Dirtheadz
Official CCB Member
Joined: Thu Jan 27, 2011 9:27 pm
Posts: 929
Location: Colorad Springs
|
Re: Pitman Arm nut 2 Thud-a-thuds, past rat a tat-tat with a 1/2" impact.
_________________
!!! Being original is a blueprint for followers !!!
|
| Sun Dec 31, 2017 6:15 pm |
|
|
|
BroncoCrawler
Official CCB Member
Joined: Sun Jul 14, 2013 9:21 am
Posts: 90
Location: Wheat Ridge, CO
|
Re: Pitman Arm nut Ford Service Manual specifies 105 - 135
I also paint mark that nut so it's easy to see if it backs off. I've had it happen several times and the paint mark is easy to check and good piece of mind.
I've had several pitman arms that had been over torqued and the nut would actually bottom on the threads and not actually tighten the arm on it's taper. When this happened the arm would slowly rock on the splines and loosen the nut up. Just got another one from Bronco Hut and this one is finally staying tight.
Sent from my XT1254 using Tapatalk
|
| Mon Jan 01, 2018 10:15 am |
|
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 5 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
