www.ColoradoClassicBroncos.com

by **71 bass boat** » Sun Mar 13, 2011 2:41 pm

Does anybody know what i should torque my new intake manifold to? and in what order? it's an edlebrok performer if that helps i'm also looking to getting new bolt's for the intake. any info would help thank's!!

matt. beer

by **Viperwolf1** » Sun Mar 13, 2011 2:50 pm

It's all on the last page of the instructions: http://www.edelbrock.com/automotive_new ... 0/2121.pdf

by **71 bass boat** » Sun Mar 13, 2011 2:57 pm

thank's viperwolf any ideas on the bolts?

by **rtreads** » Mon Mar 14, 2011 2:05 pm

...dont use crappy ones. ask me how i know

by **Viperwolf1** » Mon Mar 14, 2011 4:53 pm

I used studs for the intake. Ace has them.

by **71 bass boat** » Mon Mar 14, 2011 6:48 pm

Oooh what happened with the crappy one's i'm always intersted in a good story!! popcorn

by **MOLLEY** » Mon Mar 14, 2011 7:01 pm

mat there is a chilton manual in top draw in garage by da refrig you r welcome to go get it . i think they are 5/16 and 20 to 25 ft lbs .if i remember right . use some sealer around matting surface
cheers . Molley

by **MOLLEY** » Mon Mar 14, 2011 7:02 pm

start toward middle and chris cross for pattern
again cheers Molley

by **ClayJ** » Tue Mar 15, 2011 9:45 am

by **71 bass boat** » Wed Mar 16, 2011 6:32 pm

Sweet thanks for the info guy's. the intake is going back on tonight!! hopefully will have the motor running by the weekend!

www.ColoradoClassicBroncos.com

intake torque setting's

intake torque setting's

Re: intake torque setting's

Re: intake torque setting's

Re: intake torque setting's

Re: intake torque setting's

Re: intake torque setting's

Re: intake torque setting's

Re: intake torque setting's

Re: intake torque setting's

Re: intake torque setting's

Who is online