|
|
Register •
FAQ
• Login
|
|
|
It is currently Tue Nov 05, 2024 6:13 pm
|
|
Page 1 of 1
|
[ 2 posts ] |
|
| Author |
Message |
|
gslack
Official CCB Member
Joined: Sat Jan 08, 2011 3:20 am
Posts: 68
Images: 0
Location: Colorado Springs
|
 Liftgate issues. So there are these two prongs that retract out of the body when you turn the lift gate handle, and one of them has had problems releasing and it worked if i tightned the screw and turned the handle at a certain angle. now it seems not to work at all. so question is do i need a brand new lift gate, or is there someway to fix the moving parts.
|
| Mon Mar 07, 2011 2:27 pm |
|
|
|
Gunnibronco
Official CCB Member
Joined: Mon Jan 03, 2011 6:07 pm
Posts: 4074
Location: Gardnerville, NV
|
Re: Liftgate issues. Open the back access cover off the inside of the gate (2 philips screws). It may just need the nuts tightened, or there are simple plastic clips (that break) that hold the latch rods to the handle. The plastic clips are available at Napa or Carquest, etc.
Chad
_________________
"America is at that awkward stage. It's too late to work within the system, but too early to shoot the bastards." – Claire Wolfe
74-AWB 98", ZF5, Atlas4, TGW HP1060 and HP1014 axles, ARBs, 37's, 3.5" lift-5.5" front coil springs, Tahoe rear springs, EFI 302, h-boost, York OBA, 4x4x2, custom dash & gauges
72 U15- Explorer Sport-Candyapple Red (1 of 141)
|
| Tue Mar 08, 2011 1:15 am |
|
|
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 3 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
