|
|
Register •
FAQ
• Login
|
|
|
It is currently Thu Oct 03, 2024 5:18 pm
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Welding onto a shift fork
| Author |
Message |
|
landshark
Official CCB Member
Joined: Fri Oct 14, 2011 12:16 am
Posts: 3942
Location: Denver, Wash Park Area
|
 Welding onto a shift fork So my throwout bearing is riding the pressure plate, however just a bit of back pressure (about 1/8") is pulling the throwout bearing off so its free
because of the external slave there isn't any room to put a spring on the end of the fork, I am thinking of welding a small extension onto the end in order to have a clear line to the frame. Is there any issues with me welding to the end of the fork? I know its hardened steel but it should weld just fine I would assume? Not much pressure is needed to move the fork/throwout bearing away and with the added leverage of the extension it should work fine.
Thoughts?
_________________
1976 Bronco "Green, Yellow, whatever", 1969 Bronco "Red", 1972 Bronco Stocker "Kind of Blue/Grayish"
|
| Mon Oct 13, 2014 7:49 pm |
|
|
|
bsaunder
Official CCB Member
Joined: Sun Mar 16, 2014 8:20 am
Posts: 27
Location: ~Denver, CO
|
Re: Welding onto a shift fork Several on CB and pirate have welded to it for a hydraulic setup, so I'm thinking it's OK. I hope so as I'll be welding tabs to mine for connecting a slave to soon.
_________________
-Ben
'74 Bronco / Garage art - in stages of rising again
..figured out how to change my dork picture!
|
| Tue Oct 14, 2014 10:16 am |
|
|
|
Digger
Official CCB Member
Joined: Fri Jun 21, 2013 8:53 pm
Posts: 1276
|
Re: Welding onto a shift fork I assume this is a stamped steel piece. If so, you will have an area around the weld that will loose its heat treat, but that area you're describing is not critical. I would be more concerned if it were near the areas of greater stress.
_________________
Cummins R2.8 diesel, ZF5, AtlasII, HP44/BB9, ARBs, coiled / linked suspension, 37" KO2s, full cage, bumpers, etc.
Build Thread:
Average 23.5 mpg, Best tank: 25.1 mpg
|
| Tue Oct 14, 2014 1:01 pm |
|
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 3 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
