Heater wiring

[mustangjonny84]

So, I've got my truck in the garage for an overall dashboard sprucing up. (uncut dash, dash pad, Retrosound stereo and speaker, refreshed gauge, steering wheel, etc.) As a part of the project, I'm going back to an OEM heater box. My truck came with a Vintage Air system that was only partially installed. It just didn't have the look or functionality that I wanted.

So I got a stock box, got some stock knobs, replaced the heater core, replaced all the seals, upgraded to the Shivy motor/fan, and now I'm really starting from scratch on the wiring. Does anyone have a wiring diagram for this? Google's really letting me down. Three connections on the knob, two connections on the resistor, and then power-n-ground on the motor. What goes where? Any help would be appreciated!

Before:


Oh my...:


Nearing a half way point:

[Eck]

http://www.painlessperformance.com/Manuals/10113.pdf

I think at like page 28 is the heater wiring.


Sent from my iPhone using Tapatalk

[mustangjonny84]

You, sir, are a gentleman and a scholar. Posting a picture below for any future noobs that might stumble across this post...

[Eck]

Don't forget to also ground the blower motor


Sent from my iPhone using Tapatalk

[mustangjonny84]

Don't forget to also ground the blower motor

Sent from my iPhone using Tapatalk

For sure! That Shivy motor is a little conspicuous on how to ground it. I'm glad a bench tested it before putting it in.