Eck and I are going to be replacing the passenger side floor pan in his rig this Saturday (11/17/12) at his house in the I-70 and Colorado area. He gave me the OK to invite club members if anyone is interested in checking out the process. Not sure of time yet, but figure mid morning till some time in the afternoon. Please RSVP so we know how many people we'll have wandering around his landshark sized garage.

The Kinder Klan may be able to make it, need any tools, say air hammer or angle grinder, or possibly an experienced 15 yo floor pan replacer?

Cool! I think we're set. Eck doesn't have a compressor, so it'll be hammer and chisel to provide the motivating force. I think he's got everything else that's needed.

I can bring my sml compressor, it'll drive any of my air tools.

Thank would be awesome. I was already missing my air hammer.

Sweet- this may even make it easier. If someone has gas, I do not! Insert fart joke here. Other than that, I think I'll have just about everything. Also, have we figured out a time yet?

My wife says I've got plenty of gas. I can bring my welding bottle, too. I should have plenty left, will check it. I'm averse to early mornings, how about 10?

10 works for me. Also, I've got the primer. Can we just brush that on or do I need a paint gun?

What kind of primer?

I think I used that same CIC weld-through. I'll bring my paint guns over with me and we can make a decision re: spray vs. brush on the spot since we'll have Kinder's compressor.

Actually, I need it too. It appears to have dropped out of my nav's history.