As the subject states...need a tailgate hinge or whatever you want to call it. Bought the Bronc and she only had one in her.
Also, at some point, I need:
rear bumper with swingaway tire
soft top...probably buy new
Family cage....may be able to add to the one I have but willing to listen if any sellers.
Fold and tumble rear seat.
Also looking for a welder to start getting myself in trouble with. MM180+ or Hobart equivalent.
thanks guys.
Justin
www.ColoradoClassicBroncos.com
A place for Coloradans to unite with our love of 66-77 Ford Broncos
hinge for tailgate
3 posts
• Page 1 of 1
hinge for tailgate
by jgrow » Sun Nov 13, 2011 7:08 pm
- jgrow
- Official CCB Member
- Posts: 85
- Images: 0
- Joined: Sun Jan 09, 2011 11:16 am
Re: hinge for tailgate
by akaFrankCastle » Mon Nov 14, 2011 2:18 am
On the tailgate hinge, are you talking about the two pivot points at the bottom? If so, I have two in the garage. Replaced them with the silencers WH sells.
Stroppe'd
1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar.
The Terrible One
1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering.
1973 Stroppe Baja project
1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar.
The Terrible One
1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering.
1973 Stroppe Baja project
-
akaFrankCastle - Official CCB Member
- Posts: 4901
- Images: 0
- Joined: Wed Oct 27, 2010 5:25 pm
- Location: Colorado Springs
Re: hinge for tailgate
by jgrow » Mon Nov 14, 2011 8:56 am
No, my bad. The tailgate supports. the ones that run from the sides. Sorry for the confusion...thanks for looking.
- jgrow
- Official CCB Member
- Posts: 85
- Images: 0
- Joined: Sun Jan 09, 2011 11:16 am
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 3 guests