The GT40 lower is about .46" taller than the truck lower and BCBroncos adapter combined.

Interesting. You don't happen to have an extra, or a line on others? I know its a dumb question, but I have to ask.

Replaced the connector for the temp sending unit. Replaced a fuse in my ohm meter. Looked at the disassembled tranny on my bench. Exciting stuff.

I removed the Corbeau 4 point harnesses and installed the regular 3 point retractables from WH. What a difference! These actually work great. The use the stock seat belt holes on the floor and you only need to drill one 1/2" hole about 35" up on each side of the cage. The buckle comes in a hard-plastic sleeve that you can bend and puts the connector right in the corner of each seat.

Put on my new Autolite 2bbl. Sad day when you remove a worked 670 Holley and put on a 2bbl just so you can go up a hill. It lost a little snot but not bad.

Got to run out some winch cable to re-spool it while pulling Steve's Bronco into Zoso's garage. Now I need a new roller fairlead. And then need to run a remote winch controls into the cab so I don't have to drag out the winch controller all the time.

Finished up the wiring and mounted my front clip permanently finally and got my dash mocked up and painted. Getting closer!

looking great !

Bought a complete operational Hickey Sidewinder III 9K lb. Winch with the original manual for $300.

I call!

More

Nice. What did it come out of, cause it wasn't a Bronco?

You'll have to take a look at mine this weekend and see how the support structure is built.

Stopped by RaptorRacer's today....he and his dad are installing the full Tom's Bronco Parts power steering conversion.

I finally got my cage tied into the frame today! Took way longer than I wanted but it came out pretty good. 1.5" o.d. .25 wall tubing should be sufficient!! Cage is now tied into the frame from the very front to the very rear.

Got my 9' back together yesterday finally... hoping to get the brakes put back on and all the lines then roll it out of the way and start back up on the body/frame touch up cleaning. hoping to start painting the frame this afternoon! - ohhh optimism is great!

I picked up some old (1970's --"Arkay" ?) box speakers for $2. Anyhow, they kick a$$ and they fit my budget.

Lets see, we installed the throttle kick down, replaced the brights switch so now we have head
Lights, hung and adjusted the doors, installed a new windshield, cleaned all the glass, glued some of the lose weather seals in place.....

And drove it. seems to be burning rich, will need to adjust the carb.

Then we cleaned the garage. For the first time since october, hockey mom gets to park her car in the garage

Just in time for winter!