|
It is currently Thu Oct 31, 2024 9:31 pm
|
|
Page 1 of 1
|
[ 4 posts ] |
|
Author |
Message |
PonyCorral
Official CCB Member
Joined: Fri Dec 17, 2010 2:42 pm Posts: 297 Images: 0 Location: Arvada
|
Electrical Issues
I am having some difficulty with the electrical on my truck. It will run great for 30-50 miles and drain the battery. Occasionally when I apply the brake it will kill the motor when the battery isn't fully charged. The previous owners decided to do a great job of hacking into the electrical throughout the truck so some works and some doesn't. The last piece of the electrical puzzle is that I have hazard lights but no turn signals, horn and probably radio if it was a stocker. Let me know what could be the cause if not I am leaning towards a new harness. I just want to drive it a little more this summer before tearing into it over the winter. Thanks!
_________________ 74 Ranger 65 Fastback
|
Thu Aug 16, 2012 9:48 pm |
|
|
ZOSO
Moderator
Joined: Mon Nov 15, 2010 5:58 pm Posts: 3906 Location: Henderson, Co
|
Re: Electrical Issues
I'd suggest just rewire it. Centech is an awesome kit.
_________________ Rob
74 Ranger EFI351w, 4r70w, ARB 5.13 9in, ARB 5.13D44, and a bunch of other goodies. Best of all the family memories.
04 Mustang Cobra, KenneBell 2.2 feeding a lot of boost on E85. Tire shredding machine
New project: 77 Bronco Ranger, body work and more body work.
Very little left of a 72 durango tan explorer sport
|
Fri Aug 17, 2012 6:20 am |
|
|
akaFrankCastle
Official CCB Member
Joined: Wed Oct 27, 2010 6:25 pm Posts: 4901 Images: 0 Location: Colorado Springs
|
Re: Electrical Issues
First thing I would do is have the alternator tested at your local parts place. Next, check for a power draw in the Bronco. Disconnect the positive battery cable from the battery and using a multimeter on amperage setting, bridge the gap between the battery's positive terminal and the positive battery cable. This should show you if there is something in the truck which is drawing power when it is not supposed to or if you have something grounded out. If you find that you have something grounding out, start pulling fuses from the fuse box, one at a time, and continuing to check for a draw. When you pull a fuse that stops the draw, you will know what circuit it is on.
_________________ Stroppe'd 1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar.
The Terrible One 1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering.
1973 Stroppe Baja project
|
Fri Aug 17, 2012 8:17 am |
|
|
Bronco_Gino
Official CCB Member
Joined: Mon Sep 12, 2011 9:16 pm Posts: 16 Location: Colorado Springs
|
Re: Electrical Issues
I was having a similar problem with the turn signals on my 74 and i traced it back to the hazard switch. The power for the turn signals goes through the hazard switch. When the hazard switch is off, the turn signal switch gets power, and when you turn the hazards on, it kills power to the turn signal switch. Eventually, I figured out that my hazard switch was intermittently cutting off power to my turn signals (I could wiggle the switch and make it work). I ordered a new harness that included both switches from JBG for like $45.
|
Fri Aug 17, 2012 2:50 pm |
|
|
|
|
Page 1 of 1
|
[ 4 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 9 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|