| www.ColoradoClassicBroncos.com https://coloradoclassicbroncos.com/ |
|
| Top Molding https://coloradoclassicbroncos.com/viewtopic.php?f=4&t=1795 |
Page 1 of 1 |
| Author: | Entourage [ Wed May 18, 2011 8:21 pm ] |
| Post subject: | Top Molding |
Anyone put a weather strip or seal on the bed rails to protect the paint before installing hard top or soft top? |
|
| Author: | BFD305 [ Wed May 18, 2011 8:44 pm ] |
| Post subject: | Re: Top Molding |
Ours has the factory seal. Still had some marks when it was removed, but it had been on for 25+ years. |
|
| Author: | Jesus_man [ Thu May 19, 2011 9:01 am ] |
| Post subject: | Re: Top Molding |
You might consider ordering some rubber strips from mcmaster. That would both protect and seal. J.D. |
|
| Author: | Entourage [ Thu May 19, 2011 9:03 am ] |
| Post subject: | Re: Top Molding |
I have not checked with mcmaster - great idea! |
|
| Author: | Jesus_man [ Thu May 19, 2011 9:13 am ] |
| Post subject: | Re: Top Molding |
I needed some to space the top away from the bedrails so my soft doors would fit. I ordered 1/4" thick, but you'd go with much thinner. And the softer stuff will crush better. J.D. |
|
| Author: | MARKNE [ Thu May 19, 2011 7:06 pm ] |
| Post subject: | Re: Top Molding |
would camper seal tape work ?? Has a peel back adhesive on one side, made out of foam rubber. Any RV place would have it. |
|
| Author: | sbolt19 [ Fri May 20, 2011 9:38 am ] |
| Post subject: | Re: Top Molding |
watch out using neoprene, I have used it and it messes with the crush factor. The doors won't seal & you will have gaps all over the place. Get some really soft rubber or buy the OEM ones from JBG |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|