| www.ColoradoClassicBroncos.com https://coloradoclassicbroncos.com/ |
|
| Cutting oil https://coloradoclassicbroncos.com/viewtopic.php?f=4&t=1833 |
Page 1 of 1 |
| Author: | Justin [ Mon May 23, 2011 9:55 pm ] |
| Post subject: | Cutting oil |
Need to get some cutting oil so that I don't destroy Zoso's reamer tomorrow when I reinstall my tie rod. Home Depot doesn't carry it, Ace's is supposed to be really bad. Any suggestions about where to pick up some cutting oil of decent quality, ideally in the northern half of the metro area? |
|
| Author: | ZOSO [ Tue May 24, 2011 6:13 am ] |
| Post subject: | Re: Cutting oil |
I've got a big bottle too. Ill be at my dads after work if you wanna get it. He lives a few blocks west from dan. |
|
| Author: | Jesus_man [ Tue May 24, 2011 8:20 am ] |
| Post subject: | Re: Cutting oil |
Also, the trick with the reamer is to go very very slow. I've had better results from using a ratchet by hand than a drill. J.D. |
|
| Author: | Jesus_man [ Tue May 24, 2011 8:39 am ] |
| Post subject: | Re: Cutting oil |
Yep. Seems the smaller bits >3/8" or so do fine with higher speeds, but anything above that and I slow it down! J.D. |
|
| Author: | Justin [ Tue May 24, 2011 7:10 pm ] |
| Post subject: | Re: Cutting oil |
Thanks for the advice and offers, guys. I was able to find some while I was down in Denver today. Hope to get it done today or tomorrow. |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|