|
It is currently Mon Nov 25, 2024 2:04 am |
|
All times are UTC - 7 hours [ DST ] |
|
Page 1 of 1 |
[ 10 posts ] |
| Print view | Previous topic | Next topic |
Bad u-joint?
| Author | Message |
|---|---|
|
Official CCB Member   Joined: Wed Oct 27, 2010 6:25 pm Posts: 4901 Images: 0 Location: Colorado Springs 
|
 Bad u-joint?So I had a little driveline vibration on the Super Duty when I was driving it home from Denver. Haven't had much chance to look at it and the truck has been parked. Decided to pull the driveshaft after a quick inspection. I'm thinking this u-joint might have been bad.
 _________________ Stroppe'd 1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar. The Terrible One 1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering. 1973 Stroppe Baja project |
| Tue Jun 28, 2011 11:29 am |
|
|
|
|
Official CCB Member  Joined: Thu Nov 11, 2010 10:36 am Posts: 5984 Location: California
|
Re: Bad u-joint? Bad for you, good for scrap!
I should probably go grease mine! J.D. _________________ 1973 Bronco, 351 SEFI, Locked, discs, 35's ZF-5spd and Atlas 4spd. 235:1 Crawl Ratio. It may be ugly, but it's slow. http://www.ucora.org |
| Tue Jun 28, 2011 11:33 am |
|
|
|
|
Official CCB Member Joined: Wed Oct 27, 2010 6:25 pm Posts: 4901 Images: 0 Location: Colorado Springs
|
Re: Bad u-joint? Yeah. After pull the driveshaft, I'm gonna probably replace all the u-joints. Good prevention. Plus both caps on the next joint just fell off with no effort. Don't think I saw any grease in them.
_________________ Stroppe'd 1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar. The Terrible One 1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering. 1973 Stroppe Baja project |
| Tue Jun 28, 2011 11:35 am |
|
|
|
|
Official CCB Member  Joined: Sun Oct 10, 2010 12:04 am Posts: 6198 Images: 0 Location: Lakewood
|
Re: Bad u-joint? You're nuts. That has another 50k in it, easy.
|
| Tue Jun 28, 2011 12:09 pm |
|
|
|
|
|
Re: Bad u-joint? That'll buff out.
|
| Tue Jun 28, 2011 1:12 pm |
|
|
|
|
Official CCB Member Joined: Wed Oct 27, 2010 6:25 pm Posts: 4901 Images: 0 Location: Colorado Springs
|
Re: Bad u-joint? eh, 25k at best. Have to save the rest for the Bronco. Big thing that gave it away...the half a post seen the the bottom was not only not seated in the bearing cap, it was kicked over almost a full inch. Some heavy throttle and I'd probably have sheared it right off. _________________ Stroppe'd 1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar. The Terrible One 1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering. 1973 Stroppe Baja project |
| Tue Jun 28, 2011 1:14 pm |
|
|
|
|
Official CCB Member Joined: Sat Oct 23, 2010 9:00 pm Posts: 252
|
Re: Bad u-joint? id go with u joints that are non grease-able they're much stronger on a diesel they have alot of torque . i have been through a couple and they seem to last longer and i have mine chipped so i like to mash the pedal and watch the smoke.
|
| Tue Jun 28, 2011 6:24 pm |
|
|
|
|
Official CCB Member Joined: Wed Oct 27, 2010 6:25 pm Posts: 4901 Images: 0 Location: Colorado Springs
|
Re: Bad u-joint? _________________ Stroppe'd 1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar. The Terrible One 1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering. 1973 Stroppe Baja project |
| Tue Jun 28, 2011 9:34 pm |
|
|
|
|
Official CCB Member  Joined: Sat Nov 13, 2010 12:31 am Posts: 516 Images: 1 Location: littleton
|
Re: Bad u-joint? Weld up some nuts to the old ones and just die grind round vwala, reconditioned u joints
|
| Tue Jun 28, 2011 10:38 pm |
|
|
|
|
Official CCB Member Joined: Sun Oct 10, 2010 12:04 am Posts: 6198 Images: 0 Location: Lakewood
|
Re: Bad u-joint? Hell, I bet you could just use a helicoil to stick all the parts together.
|
| Tue Jun 28, 2011 10:57 pm |
|
|
|
|
|
Page 1 of 1 |
[ 10 posts ] |
|
All times are UTC - 7 hours [ DST ] |
Who is online |
Users browsing this forum: No registered users and 74 guests |
| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum |