| www.ColoradoClassicBroncos.com https://coloradoclassicbroncos.com/ |
|
| Anyone know where to rent a piston ring grinder? https://coloradoclassicbroncos.com/viewtopic.php?f=4&t=2732 |
Page 1 of 1 |
| Author: | airbur [ Fri Oct 14, 2011 5:53 pm ] |
| Post subject: | Anyone know where to rent a piston ring grinder? |
I tried O'Reilly, Advance, and AutoZone....no one has them. I don't really want to buy one. Thanks. |
|
| Author: | Viperwolf1 [ Fri Oct 14, 2011 6:03 pm ] |
| Post subject: | Re: Anyone know where to rent a piston ring grinder? |
I just used my dremel with a cutoff wheel. |
|
| Author: | airbur [ Fri Oct 14, 2011 6:18 pm ] |
| Post subject: | Re: Anyone know where to rent a piston ring grinder? |
No problems getting them to square up good? |
|
| Author: | Viperwolf1 [ Fri Oct 14, 2011 6:22 pm ] |
| Post subject: | Re: Anyone know where to rent a piston ring grinder? |
Not if you're careful. You need a fixture to hold either the ring or the dremel. Then just grind a little at a time. When you get close finish it up with a stone. |
|
| Author: | ZOSO [ Fri Oct 14, 2011 6:36 pm ] |
| Post subject: | Re: Anyone know where to rent a piston ring grinder? |
Talk to sp!tfire. I never found one when we built my buddies 408 in his dodge. We just used a small hand file and did very little at a time. we must have test fit each ring 10+ times. |
|
| Author: | airbur [ Fri Oct 14, 2011 8:21 pm ] |
| Post subject: | Re: Anyone know where to rent a piston ring grinder? |
I found descent ones online for around $40. I'm not near SpitFire so that's not an option unfortunately. |
|
| Author: | airbur [ Sat Oct 15, 2011 7:37 pm ] |
| Post subject: | Re: Anyone know where to rent a piston ring grinder? |
I ordered one from Amazon with free overnight shipping...hoping to have in on Monday. So if anyone else needs one, I'm happy to loan it out to club members after I'm done. |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|