| www.ColoradoClassicBroncos.com https://coloradoclassicbroncos.com/ |
|
| Revolver guys? https://coloradoclassicbroncos.com/viewtopic.php?f=4&t=4176 |
Page 1 of 1 |
| Author: | akaFrankCastle [ Thu May 31, 2012 8:05 am ] |
| Post subject: | Revolver guys? |
I've got the gun itch again and am looking for some input/reviews. Looking at a smaller hammerless revolver for general purpose. Occasional carry gun/center console piece. Have been looking at the Ruger LCR and the S&W J frames, .357. Any of you guys have one or both of these? How about some input? |
|
| Author: | trei75bronco [ Thu May 31, 2012 9:30 am ] |
| Post subject: | Re: Revolver guys? |
Taurus uses old s&w dies and they re top notch (only thin g I would buy from them) s&w j frames are also great.... Ruger lcr are great guns I would go put a couple. In your hands. I like the lightweight revolvers but they tend to hurtthe hand a little. What ever you do I would get a 357 as you can practice. With38spl. I've shot all of them and if money is no object. S&w if it is Taurus |
|
| Author: | Brianut [ Thu May 31, 2012 10:34 am ] |
| Post subject: | Re: Revolver guys? |
for what its worth I have a Taurus in .38, ultra light frame, and have been very happy with it. I know you specified .357 and Ruger/Smith but just figure I would let you know my experience with the Taurus. Should of got .357 but it was a deal I couldn't pass up. |
|
| Author: | akaFrankCastle [ Thu May 31, 2012 10:41 am ] |
| Post subject: | Revolver guys? |
I'm not opposed to Taurus, I just don't see many used ones pop up on the RMGO classifieds. Dan, there's a 329PD over on RMGO with a Magnaport job I was tempted on. Both of those guns are K frame and I was thinking something smaller and lighter. I'm very happy with large caliber guns and love my .45 to death. However, with summer time coming I was thinking smaller and lighter for the shorts and flip flops days. Putting on my belt with shorts to carry the Springfield is starting to finally wear on me finally after 5 years. |
|
| Author: | Badlands [ Thu May 31, 2012 10:46 am ] |
| Post subject: | Re: Revolver guys? |
My revolvers are bigger brutes, Taurus Tracker 44 mag and Ruger Vaquero Colt 45. They are to make me feel more manly and pretend I'm a  . Kel-tec sometimes gets a bad wrap, but I also have a little 9mm that you can conceal in your hand practically. The little Taurus 38 feels good in your hand and is far less expensive than the Smithy. Adding a rubber hand grip, depending on the weapon, makes them a bit more more comfortable. |
|
| Author: | akaFrankCastle [ Thu May 31, 2012 11:53 am ] |
| Post subject: | Revolver guys? |
I still miss my Anaconda. Sold it, like a fool, for 400 back in 98 and now they're going for 900-1500. |
|
| Author: | Moab Mike [ Thu May 31, 2012 12:01 pm ] |
| Post subject: | Re: Revolver guys? |
I have a J frame in .38 Special, nice and compact. I have a K frame in .38 Special with a 2" barrel that I really like and I have an N frame in .44 Magnum that I carry when I'm hunting. I have an older Taurus in .357 Magnum too. You can't go wrong with any quality wheel gun IMHO because of the reliability! You. Could find a good buy on a revolver and bob the hammer yourself too. |
|
| Author: | akaFrankCastle [ Thu May 31, 2012 1:17 pm ] |
| Post subject: | Re: Revolver guys? |
Doing a little quick research here at work. A little shootout of sorts when it comes to a few items I found/liked. Glock 26 9mm 10 rounds 26.10oz loaded/19.75oz dry Glock 36 .45 ACP 6 rounds 26.99oz loaded/20.11oz dry Ruger LCP .380 6+1 9.40oz (not specified but I would assume dry) $379.00 MSRP Ruger LCR .357 5 rounds 17.10oz $599.00 MSRP Smith and Wesson 640PD .357 5 rounds 11.4oz dry $1019.00 MSRP (Titanium ain't cheap, I guess) Taurus 650BP .357 5 rounds 24.2oz $508.00 MSRP (plus 1 year free NRA membership. Whoopty do.) Think I am going to rule out the Taurus unless I find another model that has been on a diet. With that type of weight, I might as well carry the Glock 36. The Smith 640 is pricey. I was hoping to stay ~500.00 for the purchase, keeping my +1000.00 purchase in reserve for when I pick up my Springfield M1A. The Ruger LCP is great price wise, but a .380. The Ruger LCR looks like a front runner, but I can get either one of the Glocks for cheaper and knowing that the .45 ACP (Glock 36) is very tempting. I think I just need to dip into the savings and buy all of them.  Right now, I'm thinking toss up between the Glock 36 and the Ruger LCR. But it is still early in the game. |
|
| Author: | Gunnibronco [ Thu May 31, 2012 1:48 pm ] |
| Post subject: | Re: Revolver guys? |
Curious what shooting a 357 from the LCR feels like. I know shooting a S&W Airweight .38 Special was surprisingly uncomfortable. Ruger SP101 357 is my suggestion. It is available in a hammerless double action only, and like a 1.25" barrel. That is the model my friend has & I love shooting it. I just picked up a Ruger GP101, but with a 6" full shroud barrel, its far from a carry gun. Not even sure I want to carry it in the woods, it weighs a ton and pulling a 6" barrel from a holster is not going to be quick. |
|
| Author: | sbolt19 [ Thu May 31, 2012 3:05 pm ] |
| Post subject: | Re: Revolver guys? |
| Author: | ffcobronco [ Fri Jun 01, 2012 1:32 pm ] |
| Post subject: | Re: Revolver guys? |
The LCR has one of the best if not the best trigger I have pulled. very accurate for such a short barrel also. |
|
| Author: | trei75bronco [ Fri Jun 01, 2012 8:58 pm ] |
| Post subject: | Re: Revolver guys? |
I have a lcp and they are hard to hold fyi. Carry gun only IMHO |
|
| Author: | Shawns Fords [ Sun Jun 10, 2012 9:41 am ] |
| Post subject: | Re: Revolver guys? |
We had a Ruger 38 for 299.00 at Bass Pro. We have the Taurus 357 and 22 revolvers and I would have one of each if I had that kind of extra cash floating around. We also have the Josey Wales Colt Walker revolvers and that is going to be my first purchase. Revolvers are the best home defense product a person can have. Never fail, will always work. http://www.imfdb.org/wiki/Outlaw_Josey_Wales,_The |
|
| Author: | pilosopher [ Tue Aug 28, 2012 7:48 am ] |
| Post subject: | Re: Revolver guys? |
Did you get one frankencastle? Im going to 2nd the vote for a Ruger SP101 in .357. Got one for my wifes purse, and she loves it. She's just a little thing and can handle full power loads in it. Im more of an old schooler and carry either a browning hi-power 9mm, or a Mauser HSc .380. |
|
| Author: | Entourage [ Tue Aug 28, 2012 9:13 am ] |
| Post subject: | Re: Revolver guys? |
I can shoot my Blackhawk .357 with a 4" barrel more accurately than anything else in my collection. |
|
| Author: | akaFrankCastle [ Fri Aug 31, 2012 4:06 pm ] |
| Post subject: | Re: Revolver guys? |
| Author: | ZOSO [ Sat Sep 01, 2012 4:40 pm ] |
| Post subject: | Re: Revolver guys? |
Just picked up a new Springfield xd-s today for my new carry pistol. Can't wait to shoot it in a few days. |
|
| Author: | valentino [ Sat Sep 22, 2012 9:24 am ] |
| Post subject: | Re: Revolver guys? |
Get this one and do this |
|
| Author: | akaFrankCastle [ Sat Sep 22, 2012 2:59 pm ] |
| Post subject: | Re: Revolver guys? |
Ha! Love that's guys videos. On the subject of revolvers, I shot the LCR in 380 and the Sig something another in 9mm this week. Both mostly polymer guns with light, concealed carry in mind. Didn't like either one of them. The search continues. For anyone who might have a Springfield 1911 Champion model (4.25" Commander length slide), might be a good idea to put some Locktite on that intricate, 300 piece guide rod and spring assembly. My buddy's pretty much came apart on him on the range. Better yet, replace it with a full length piece. |
|
| Author: | ZOSO [ Sat Sep 22, 2012 4:15 pm ] |
| Post subject: | Re: Revolver guys? |
For a ccw look at the xds if you don't want a revolver. |
|
| Author: | Booger [ Sat Sep 22, 2012 7:45 pm ] |
| Post subject: | Re: Revolver guys? |
| Author: | akaFrankCastle [ Sat Sep 22, 2012 8:34 pm ] |
| Post subject: | Re: Revolver guys? |
| Author: | pilosopher [ Sun Sep 23, 2012 9:17 pm ] |
| Post subject: | Re: Revolver guys? |
if you like 1911's (I do too)....have you shot a Browning Hi-Power 9mm? it's not quite as bulky as a 1911, similar design, and carries pretty well. that's what I'm usually slingin when I'm wearing a coat of some sort. it is a little noticeable if a shirt and jeans is all I'm wearing. try one out, it's my favorite pistol ever |
|
| Author: | Gunnibronco [ Mon Sep 24, 2012 7:49 am ] |
| Post subject: | Re: Revolver guys? |
Check out Smith & Wesson M&Ps. I have a couple 40's, a compact for CCW & full size. I really like them. I just shot a Gen4 Glock on Friday, and did not like the way if felt. They don't call them "Blocks" for nothing. S&W is made in USA, excellent lifetime warranty, great customer service. I had lead fouling on the crown of a barrel & bullet jackets peeling off, it was the ammo's fault, but S&W sent me a new barrel, with custom polished feed ramp & 2 free magazines for my trouble. |
|
| Author: | akaFrankCastle [ Tue Oct 02, 2012 4:59 pm ] |
| Post subject: | Re: Revolver guys? |
Well, I found a solution, if only temporarily. Or should I say a solution found me. Co-worker came in yesterday talking about wanting to buy a P99 and needing to unload his SA XD subcompact 9mm. Not really being a fan of the model, I asked him how much he wanted thinking the price point would immediately deter me from buying it. BUT, 325.00 and I now I have a new gun.
|
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|