| www.ColoradoClassicBroncos.com https://coloradoclassicbroncos.com/ |
|
| Parts washer questions https://coloradoclassicbroncos.com/viewtopic.php?f=4&t=4669 |
Page 1 of 1 |
| Author: | Justin [ Sun Sep 23, 2012 11:01 pm ] |
| Post subject: | Parts washer questions |
I got a parts washer awhile back and am working to get refinished and set up. Anyone have a favorite cleaner that is non-flammable? I was figuring on Simple Green or something equivalent, but thought I'd see if anyone had a product that was better. Also, I need to repaint it and would like a finish that will stand up to long term submersion in a water based cleaner. Any ideas? Something resistant to mineral spirits or the like would be a plus, but $$ are a consideration. |
|
| Author: | ManTruck [ Mon Sep 24, 2012 5:26 am ] |
| Post subject: | Re: Parts washer questions |
I use Purple stuff, which is similar to the simple green. Works great for me. |
|
| Author: | ZOSO [ Mon Sep 24, 2012 6:07 am ] |
| Post subject: | Re: Parts washer questions |
I agree with man truck. Purple stuff works a lot better than simple green. Its rough on the hands so get some good rubber gloves. |
|
| Author: | Kinder [ Mon Sep 24, 2012 9:49 am ] |
| Post subject: | Re: Parts washer questions |
X3 on the purple. |
|
| Author: | Justin [ Mon Sep 24, 2012 9:56 am ] |
| Post subject: | Re: Parts washer questions |
Looks like purple stuff is the winner! Will it eat or penetrate Krylon? |
|
| Author: | ManTruck [ Mon Sep 24, 2012 4:08 pm ] |
| Post subject: | Re: Parts washer questions |
I think it will if you let it soak long. If you just was it and clean it I believe you will be OK. I do not cut mine and run straight without a water mix. It would be good with a 50/50 solution but you need to experiment a little. |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|