| www.ColoradoClassicBroncos.com https://coloradoclassicbroncos.com/ |
|
| Explorer cam https://coloradoclassicbroncos.com/viewtopic.php?f=4&t=5857 |
Page 1 of 1 |
| Author: | Broncoguy73 [ Sun Jan 05, 2014 8:43 pm ] |
| Post subject: | Explorer cam |
I'm going to the explorer EFI set up while still using my 72 block for now which means the wrong firing order. Slim chance but I figured I would see if any one had a cam from a late 90's explorer 5.0? |
|
| Author: | crawlercreations [ Sun Jan 05, 2014 8:49 pm ] |
| Post subject: | Re: Explorer cam |
........... |
|
| Author: | Broncoguy73 [ Sun Jan 05, 2014 8:58 pm ] |
| Post subject: | Re: Explorer cam |
I need the roller block before if get the roller cam... Duh |
|
| Author: | plumbdoctor [ Mon Jan 06, 2014 12:36 am ] |
| Post subject: | Re: Explorer cam |
It will still run fine with the old order |
|
| Author: | Gunnibronco [ Mon Jan 06, 2014 9:17 am ] |
| Post subject: | Re: Explorer cam |
I bet EFI Guy can reprogram the spark plug & injector firing order to match the cam. He can do it with the Mustang EFI. I'm running the Mustang EFI with my old cam and incorrect injector firing order, and it runs fine. You might be able to use the Explorer cam, there are aftermarket "dog bone" retainers to fit roller lifters in an old block. I'm not 100% sure how its done, but I think it will work. |
|
| Author: | Eck [ Mon Jan 06, 2014 9:36 am ] |
| Post subject: | Re: Explorer cam |
L |
|
| Author: | B.O.B. [ Mon Jan 06, 2014 9:44 am ] |
| Post subject: | Re: Explorer cam |
I put a 351 cam in that is the right firing order. Wasn't to expensive. |
|
| Author: | Viperwolf1 [ Mon Jan 06, 2014 10:36 am ] |
| Post subject: | Re: Explorer cam |
| Author: | Gunnibronco [ Mon Jan 06, 2014 10:47 am ] |
| Post subject: | Re: Explorer cam |
| Author: | Broncoguy73 [ Mon Jan 06, 2014 1:14 pm ] |
| Post subject: | Re: Explorer cam |
Im just going to roll with what i have since everyone says it will run fine. Down the road ill do the full swap with a explorer motor plus the 4r70w |
|
| Author: | EFI Guy [ Mon Jan 06, 2014 6:06 pm ] |
| Post subject: | Re: Explorer cam |
| Author: | Broncoguy73 [ Mon Jan 06, 2014 6:12 pm ] |
| Post subject: | Re: Explorer cam |
You are the man! |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|