| www.ColoradoClassicBroncos.com https://coloradoclassicbroncos.com/ |
|
| Measurement needed https://coloradoclassicbroncos.com/viewtopic.php?f=4&t=6622 |
Page 1 of 1 |
| Author: | Justin [ Wed Jul 23, 2014 12:40 pm ] |
| Post subject: | Measurement needed |
Could a couple of people with lifts in the 3-4.5" range please give me the measurement between the bottom of the frame rail and the top of the front axle tube? Trying to figure out what my ride height will be. |
|
| Author: | BNC04 [ Wed Jul 23, 2014 1:55 pm ] |
| Post subject: | Re: Measurement needed |
Justin I'm right at 10 1/2 inches with new WH progressive 3.5 inch springs and heavy duty coil cups. Medium weight front bumper, steel hood and older ramsey winch with synthetic rope. Brett |
|
| Author: | Kinder [ Wed Jul 23, 2014 7:08 pm ] |
| Post subject: | Re: Measurement needed |
I suppose you don't want the measurement from BSD? |
|
| Author: | Justin [ Wed Jul 23, 2014 7:42 pm ] |
| Post subject: | Re: Measurement needed |
Meh, I'll take whatever. I'm just trying to get a rough idea. I'd take one off TFB too. |
|
| Author: | Digger [ Wed Jul 23, 2014 10:43 pm ] |
| Post subject: | Re: Measurement needed |
- Mine was 6" top of axle tube to bottom of frame stock. - Deaver 3.5" coils pushed it up to 9.75" - 10.0" It should sink to 9.5" when fully weighted, which is ~1000 lbs of sprung mass per coil in front. |
|
| Author: | Justin [ Thu Jul 24, 2014 12:00 am ] |
| Post subject: | Re: Measurement needed |
Cool, thanks. Sounds like 10" may be a good starting point. |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|