| www.ColoradoClassicBroncos.com https://coloradoclassicbroncos.com/ |
|
| Drill press repair https://coloradoclassicbroncos.com/viewtopic.php?f=4&t=6735 |
Page 1 of 1 |
| Author: | Justin [ Sun Aug 24, 2014 2:58 pm ] |
| Post subject: | Drill press repair |
The chuck on my drill press randomly fell off after a number of years of service. The mating surfaces have gotten scratched up, so it's not re-seating. I polished up the shaft. Is there an easy way to clean up the inside of the chuck, or do I need to suck it up and buy a new one? |
|
| Author: | 71 Broncman [ Mon Aug 25, 2014 6:49 am ] |
| Post subject: | Re: Drill press repair |
Could try a sanding drum on a Dremel tool followed by a polishing wheel. Care would have to be used to not grind down taper. Mark. |
|
| Author: | Woodscaper [ Mon Aug 25, 2014 8:52 am ] |
| Post subject: | Re: Drill press repair |
I think I have a brand new chuck still in the box if you end up needing a new one, let me know and I will dig out. |
|
| Author: | mickphatmac [ Mon Aug 25, 2014 10:34 am ] |
| Post subject: | Re: Drill press repair |
HA! Same thing happened to mine about 2 years ago. Drilling something small, and "crap", just fell off. I also figured I had nothing to loose, either beat it into submission or buy a new one!... Like I said, 2 years later...BFH! |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|