| www.ColoradoClassicBroncos.com https://coloradoclassicbroncos.com/ |
|
| I Don't Want To, But Might Have To https://coloradoclassicbroncos.com/viewtopic.php?f=4&t=7062 |
Page 1 of 1 |
| Author: | cplynn [ Fri Dec 19, 2014 7:34 am ] |
| Post subject: | I Don't Want To, But Might Have To |
Looks like I might have to sell my Bronco out of necessity. Wanted to put out a post for some feelers on what you guys think is a good asking price. Some of you have seen my Bronco up close. Here is the lowdown on mods, etc. Year: 1974, Ranger Years Owned: 4 Very minimal rust. Since I bought it here is a list of what has been done: Drive Train: Engine: Crate EFI 5.8L Ford Lightning (purchased long block new from a guy who won it in a raffle and did not have a project for). GT40 heads Ford Lightning upper and lower intakes Explorer serpentine front dress A9P ECM RJM EFI harness All new sensors New 70mm BBK Mass Air Flow Sensor Wild Horses ceramic coated long tube headers to two into one exhaust, Flowmaster muffler Wild Horses Extreme Engine Mounts Transmission: ViperBuilt C4 Transfer Case: ViperBuilt D20, with Wild Horses Twin Stick Brakes: Chevy front disc brake conversion with all new calipers, rotors and brake lines. Chevy Astrovan Hydroboost Stock drums in rear Summit racing adjustable prop valve Warn Premium locking hubs Interior: New Carpet from TBP 8 point Family Roll cage from Bob's Broncos Grant Steering Wheel Suspension: Stock suspension but new Wild Horses shocks at all four corners Wild Horses 2.5" body lift Tires: 31" BFG A/Ts, need to figure out how many miles are on them, but it's not much. I've put a lot of work into this thing so far and it pains me to even think about selling it, but it looks like I'll probably have to. Posting a few pics to hopefully give an indication of the shape it's in. It starts right up even in cold weather and runs well. |
|
| Author: | hockeydad4-22 [ Fri Dec 19, 2014 10:25 am ] |
| Post subject: | Re: I Don't Want To, But Might Have To |
Spend a Saturday with a buffer and she is probably a 10K rig. |
|
| Author: | Justin [ Fri Dec 19, 2014 1:09 pm ] |
| Post subject: | Re: I Don't Want To, But Might Have To |
x2. If you can get the seats back in so that it's driveable, polish it up and get the dirt out of the interior it'll be 10k easy. I'd be tempted to include the carpet kit but not install it so that people can see the condition of the sheet metal. Bummer you have to sell! |
|
| Author: | cplynn [ Fri Dec 19, 2014 2:39 pm ] |
| Post subject: | Re: I Don't Want To, But Might Have To |
Seats and carpet are in and it's totally driveable. I only put those interior shots in to kind of show what it looks like under the carpet. I was hoping I could get around $14k for it. Think that's too steep? |
|
| Author: | Justin [ Fri Dec 19, 2014 4:53 pm ] |
| Post subject: | Re: I Don't Want To, But Might Have To |
Worth a shot. Ebay may get you the most $$. |
|
| Author: | landshark [ Fri Dec 19, 2014 5:04 pm ] |
| Post subject: | Re: I Don't Want To, But Might Have To |
I think 15k at least I would ask for more as allot of what people want in a bronco has already been done. I would push it to 20+ you can always come down. |
|
| Author: | Digger [ Fri Dec 19, 2014 5:35 pm ] |
| Post subject: | Re: I Don't Want To, But Might Have To |
10K seems low compared to what's out there. I saw 4 last night for 28-35K For what you have, try starting at 15K and see where it goes. |
|
| Author: | Rox Crusher [ Fri Dec 19, 2014 5:56 pm ] |
| Post subject: | Re: I Don't Want To, But Might Have To |
If that engine bay is still as clean as the pic And low miles on engine, trans, transfer case Replace the broken flair Wax it I think 15k is a reasonable / fair price for you and buyer |
|
| Author: | akaFrankCastle [ Sat Dec 20, 2014 3:27 am ] |
| Post subject: | Re: I Don't Want To, But Might Have To |
Advertise outside of the arid west. We take low rust trucks for granted and subsequently will lowball you. Target the Midwest and south aka rust belt. Ask 20k+ and go from there. |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|