| www.ColoradoClassicBroncos.com https://coloradoclassicbroncos.com/ |
|
| Measurement needed https://coloradoclassicbroncos.com/viewtopic.php?f=4&t=7099 |
Page 1 of 1 |
| Author: | akaFrankCastle [ Thu Jan 08, 2015 3:22 pm ] |
| Post subject: | Measurement needed |
Bottom of the frame rail to the bottom of the rocker. Outside width between frame rails. Thanks. |
|
| Author: | Woodscaper [ Sat Jan 10, 2015 2:19 am ] |
| Post subject: | Re: Measurement needed |
So, my rockers hang down 1" below the frame rail. I do have the rock skis however, so they add at least 1/4" as to the thickness of the ski. As for outside to outside of frame rails I am at 29 1/4" just behind T-case. |
|
| Author: | akaFrankCastle [ Sat Jan 10, 2015 2:28 am ] |
| Post subject: | Re: Measurement needed |
Thanks. |
|
| Author: | Digger [ Sat Jan 10, 2015 11:45 pm ] |
| Post subject: | Re: Measurement needed |
Most of the frame is 29.5". From about the engine mounts forward it necks down to 29.25". Why they didn't make it the same all the way I don't know. Measurements on my frame vary slightly from the picture, so beware of build variation. |
|
| Author: | akaFrankCastle [ Sun Jan 11, 2015 1:39 am ] |
| Post subject: | Re: Measurement needed |
| Author: | Digger [ Sun Jan 11, 2015 10:45 pm ] |
| Post subject: | Re: Measurement needed |
Can't take credit for that one, but I have been using it to make an awesome CAD model of the frame. I dropped the complete picture in the technical links thread. It has more views and sections. Very accurate. |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|