|
|
Register •
FAQ
• Login
|
|
|
It is currently Mon Nov 25, 2024 7:33 am
|
|
Page 1 of 1
|
[ 5 posts ] |
|
"Cope cut" layout in large diameter pipe
| Author |
Message |
|
Woodscaper
Official CCB Member
Joined: Fri Nov 19, 2010 11:16 pm
Posts: 587
Location: Lakewood/Green Mtn.
|
 "Cope cut" layout in large diameter pipe Anybody have short cuts on layout and cutting a 90 degree cope/saddle cut in a 20" diameter .250 wall pipe?
I have the cutting tools, just need layout advice.
Thanks.
|
| Wed Apr 08, 2015 7:26 pm |
|
|
|
JGZ
Official CCB Member
Joined: Sat Oct 23, 2010 3:20 pm
Posts: 393
Location: Pueblo West
|
Re: "Cope cut" layout in large diameter pipe Cut out a 20" circle on poster board ,lay that down and trace it.
|
| Wed Apr 08, 2015 9:19 pm |
|
|
|
Dirtheadz
Official CCB Member
Joined: Thu Jan 27, 2011 9:27 pm
Posts: 929
Location: Colorad Springs
|
Re: "Cope cut" layout in large diameter pipe I thought their used to be a formula for large pipe, something like 1/4 of the diameter. Hell... I really did drop out & become a statistic, when I thought I wanted to be a mechanical engineer.
_________________
!!! Being original is a blueprint for followers !!!
|
| Thu Apr 09, 2015 2:37 pm |
|
|
|
Woodscaper
Official CCB Member
Joined: Fri Nov 19, 2010 11:16 pm
Posts: 587
Location: Lakewood/Green Mtn.
|
Re: "Cope cut" layout in large diameter pipe Here is a formua:
X = (R1/Sin (JA)) - (((R1 - Sqr(R1^2-(Cos ( AP ) * R2)^2)) / Sin(JA)) + ((Tan (90 - JA) * (Sin(AP) * R2))))
R1 = large radius
R2 = small radius
JA = Joint Angle
AP = AnglePosition
I also found a method of laying out a pattern.
|
| Thu Apr 09, 2015 4:31 pm |
|
|
|
Unaweep
Official CCB Member
Joined: Thu Sep 12, 2013 3:02 pm
Posts: 291
Location: Grand Junction, Co.
|
Re: "Cope cut" layout in large diameter pipe You can purchase paper templates at your welding store, they aren't expensive and will last a lifetime and work on many sizes of tube/pipe and various degrees/angles.
Erik
_________________
1969 Ford Bronco with: 351W, Q-Jet, ARB front locker, 3" Suspension lift, NP435 transmission, 33" Goodyear's, roll cage, body rough.
|
| Sun Apr 12, 2015 8:40 am |
|
|
|
|
|
Page 1 of 1
|
[ 5 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 39 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
