|
|
Register •
FAQ
• Login
|
|
|
It is currently Mon Nov 25, 2024 4:41 am
|
|
Page 1 of 1
|
[ 3 posts ] |
|
| Author |
Message |
|
akaFrankCastle
Official CCB Member
Joined: Wed Oct 27, 2010 6:25 pm
Posts: 4901
Images: 0
Location: Colorado Springs
|
 Tool rant Why is it becoming so increasingly hard to find tools?!?!?
I need a T handle Torx driver in T27. You'd think I was asking people in Pashtu for directions to the nearest nuclear research facility!
If you're tired of Amazon and the rest of the Internet kicking your ass in the market place, maybe you should remove your head from your ass.
_________________
Stroppe'd
1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar.
The Terrible One
1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering.
1973 Stroppe Baja project
|
| Sat May 23, 2015 6:02 pm |
|
|
|
Booger
Official CCB Member
Joined: Thu Dec 23, 2010 6:55 pm
Posts: 809
Location: Broomfield
|
Re: Tool rant We have Tool Zone here in the north end of Denver and they have just about anything. Last summer I was looking for a 15/16 crows foot. Go ahead and try and find one of those. Typical cheap chinese stuff has 7/8 and 1" but not 15/16" Found a set at Tool Zone. Too bad I had to grind the hell out of the crows foot so I could remove my oil pressure sending unit on my Harley Road King.
_________________
Bob - Turning hydrocarbons into noise since 1970
Spiritual owner of the now Zoso mobile (1974 Bronco Ranger - EFI 351W-4R70W-ARB front and rear-STC softtop- High Country hood-3 1/2" WH lift- Cross inboard rear shock mnt- Duffs bumpers- Warn 8274- 33's- Cheby disc conversion)
|
| Sat May 23, 2015 6:23 pm |
|
|
|
sykanr0ng
Official CCB Member
Joined: Thu Jan 22, 2015 1:46 am
Posts: 405
Location: Greeley, CO
|
Re: Tool rant The trouble is that anyone that actually knows anything about the job needs to be paid accordingly.
So they are replaced by a mouth-breather that will work for minimum wage.
_________________
"You say overkill like it's a bad thing."
|
| Sat May 23, 2015 7:41 pm |
|
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 28 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
