| www.ColoradoClassicBroncos.com https://coloradoclassicbroncos.com/ |
|
| Machining heads https://coloradoclassicbroncos.com/viewtopic.php?f=4&t=8598 |
Page 1 of 1 |
| Author: | Justin [ Sun Aug 21, 2016 10:51 am ] |
| Post subject: | Machining heads |
I need to have my GT40 heads shaved down a little. Anyone have a shop that would do a good job at a reasonable price? Also, any thoughts on what a reasonable price would be? |
|
| Author: | Kinder [ Sun Aug 21, 2016 12:40 pm ] |
| Post subject: | Re: Machining heads |
Western Engine Supply off I25 & 70th did the work on W's heads. The prices were reasonable. |
|
| Author: | Viperwolf1 [ Sun Aug 21, 2016 1:31 pm ] |
| Post subject: | Re: Machining heads |
Might be a good idea to have the bolt holes enlarged to fit 351w bolts too. |
|
| Author: | Justin [ Sun Aug 21, 2016 2:12 pm ] |
| Post subject: | Re: Machining heads |
Thanks, I'll see what the cost is. I was considering using a hole stretcher. |
|
| Author: | ZOSO [ Sun Aug 21, 2016 6:02 pm ] |
| Post subject: | Re: Machining heads |
usa performance. north of western on washington. it was 150 for up to .015" shaved off. They had it done in just a few hours. |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|