|
It is currently Sun Nov 24, 2024 2:51 pm |
|
All times are UTC - 7 hours [ DST ] |
|
Page 1 of 1 |
[ 3 posts ] |
| Previous topic | Next topic |
torque specs for '69
| Author | Message |
|---|---|
|
Official CCB Member  Joined: Mon Jul 18, 2011 9:03 am Posts: 25 
|
 torque specs for '69Hi everyone,
Can anyone tell me what the correct torque specs are for the front drive shaft U-bolts at the axle end (D30) and the drive shaft flange bolts at the tranfer case end (D20)? Same question for the rear drive shaft with a 9" rear axle. I have a shop manual but have not found the correct numbers. Any help is greatly appreciated. Thanks, Jeff |
| Wed Jul 27, 2011 8:42 am |
|
|
|
|
Official CCB Member  Joined: Mon Jan 03, 2011 6:07 pm Posts: 4074 Location: Gardnerville, NV
|
Re: torque specs for '69 I read that overtightening ujoint straps is a primary cause of premature u-joint failure.
1310 and 1330 series joint retention hardware should be tightened to 17 ft/lbs and 1350 joint hardware to 20 ft.lbs. DO NOT over tighten the retention hardware as it will distort the bearing cap and cause the bearings and joint to fail. copied from: http://www.pirate4x4.com/tech/billavist ... ndex3.html You probably have 1310s U-joints, I don't know about the D30 for sure but D44s are. Chad _________________ "America is at that awkward stage. It's too late to work within the system, but too early to shoot the bastards." – Claire Wolfe 74-AWB 98", ZF5, Atlas4, TGW HP1060 and HP1014 axles, ARBs, 37's, 3.5" lift-5.5" front coil springs, Tahoe rear springs, EFI 302, h-boost, York OBA, 4x4x2, custom dash & gauges 72 U15- Explorer Sport-Candyapple Red (1 of 141) |
| Wed Jul 27, 2011 5:17 pm |
|
|
|
|
Official CCB Member Joined: Mon Jul 18, 2011 9:03 am Posts: 25
|
Re: torque specs for '69 |
| Thu Jul 28, 2011 8:17 am |
|
|
|
|
|
Page 1 of 1 |
[ 3 posts ] |
|
All times are UTC - 7 hours [ DST ] |
Who is online |
Users browsing this forum: No registered users and 16 guests |
| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum |