Should correspond to MY 1974 and 1975 as far as I know. 10" brakes / 3/8in bolt holes in flanges / "torino" end pattern I believe
Planning to build a new rearend this winter. Expect to buy a fresh housing from a vendor but figured might as well at least try to find a used one first.
www.ColoradoClassicBroncos.com
A place for Coloradans to unite with our love of 66-77 Ford Broncos
WTB medium duty lg bearing housing (EB width)
6 posts
• Page 1 of 1
WTB medium duty lg bearing housing (EB width)
by OldBalls » Mon Jun 22, 2020 5:03 pm
Last edited by OldBalls on Tue Jun 23, 2020 11:59 am, edited 1 time in total.
- OldBalls
- Posts: 16
- Joined: Mon Nov 23, 2015 8:29 pm
- Location: Conifer
Re: WTB medium bearing housing (EB width)
by Viperwolf1 » Mon Jun 22, 2020 8:06 pm
Medium duty with big bearings and 10" brakes?
-
Viperwolf1 - Official CCB Member
- Posts: 1485
- Joined: Tue May 07, 2013 9:37 pm
Re: WTB medium bearing housing (EB width)
by pgilbeau » Mon Jun 22, 2020 9:31 pm
I have a '74-75 early Bronco housing and a new Yukon 31 spline axle shaft kit I have been trying to sell. The housing has been hot tanked to get all the grease off. This is the kit I have: https://www.randysworldwide.com/product ... onco-4-31/
You do not have the required permissions to view the files attached to this post.
1969 Bronco: Full widths, 3 linked front end, 37's, hydro-boost, 4x4x2 box, ZF5, Atlas t-case, and fuel injected 302
- pgilbeau
- Official CCB Member
- Posts: 640
- Joined: Sun Jul 07, 2013 5:06 pm
- Location: Falcon, CO
Re: WTB medium bearing housing (EB width)
by OldBalls » Tue Jun 23, 2020 9:32 am
Yes that's correct medium duty big bearing 10" brakes 3/8" bolt holes on flanges. I'll see if I can edit the post to clarify.
Will PM about the housing. As it happens I already have that same axleshaft kit. Thx guys.
Will PM about the housing. As it happens I already have that same axleshaft kit. Thx guys.
- OldBalls
- Posts: 16
- Joined: Mon Nov 23, 2015 8:29 pm
- Location: Conifer
Re: WTB medium duty lg bearing housing (EB width)
by OldBalls » Tue Jun 23, 2020 5:33 pm
Looks like the housing is sourced. Thanks Phil!
- OldBalls
- Posts: 16
- Joined: Mon Nov 23, 2015 8:29 pm
- Location: Conifer
WTB 4.88 gear set 9"
by OldBalls » Thu Jun 25, 2020 9:40 am
Looking for quality parts in decent shape... plan to drive this truck a lot
- OldBalls
- Posts: 16
- Joined: Mon Nov 23, 2015 8:29 pm
- Location: Conifer
6 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest