|
It is currently Thu Nov 21, 2024 3:54 pm |
|
All times are UTC - 7 hours [ DST ] |
|
Page 1 of 1 |
[ 3 posts ] |
| Previous topic | Next topic |
1/4 to1/2inch sheet metal/plating
| Author | Message |
|---|---|
|
Official CCB Member   Joined: Sat Nov 13, 2010 12:31 am Posts: 516 Images: 1 Location: littleton 
|
 1/4 to1/2inch sheet metal/plating]Checking if anyone has some good structural metal to build a truss. All the metal dealers are saying that I need to buy a whole sheet which is out of budget and heavy. Don't need much. Let me know, or if you know were to get smaller chunks.
|
| Wed Mar 16, 2011 4:02 pm |
|
|
|
|
Official CCB Member Joined: Sat Nov 13, 2010 12:31 am Posts: 516 Images: 1 Location: littleton
|
Re: 1/4 to1/2inch sheet metal/plating Good to know thank you
|
| Wed Mar 16, 2011 7:12 pm |
|
|
|
|
Official CCB Member  Joined: Thu Nov 11, 2010 10:36 am Posts: 5984 Location: California
|
Re: 1/4 to1/2inch sheet metal/plating K&K is a good source. I used them a lot when I lived up there. They may have what you need laying around.
J.D. _________________ 1973 Bronco, 351 SEFI, Locked, discs, 35's ZF-5spd and Atlas 4spd. 235:1 Crawl Ratio. It may be ugly, but it's slow. http://www.ucora.org |
| Mon Mar 28, 2011 2:42 pm |
|
|
|
|
|
Page 1 of 1 |
[ 3 posts ] |
|
All times are UTC - 7 hours [ DST ] |
Who is online |
Users browsing this forum: No registered users and 10 guests |
| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum |