Has anyone else installed one of these yet? How did you put the retaining bolt in to keep the synchronizer put?

Also- with collar- only about 1/4inch of the oil pump shaft is engaged. EFIGuy gave me a part number for a longer shaft. I wasn't aware the shaft needed replacing so keep that in mind for anyone planning to do this in the future.

That will need to be clocked correctly. The 5.0 is clocked parallel to the centerline of the engine. It also requires a special tool to hold the sensor in place when your installing it.

That pink stuff wipes off (unless your trying to steal shawntell's motif)

I've got ya covered on the tool to clock it correctly.

For the hold down ya gotta be creative. I've seen a longer bolt with washers welded together and ground for clearance, or two hold downs welded together like this:

Yah- it's not installed yet- just test-firing it. I am thinking of painting it pink though.

Bonus points if you can construct the hold down using nothing more than pink zip-ties.

LMAO Eck. I may be able to scrounge some spacers that may work. Do you know what length is needed Garry?

Any reason this wouldn't work?

I cut an extra groove for the hold down. I will add a few set screws to lock the collar to the synchro.
20141215_163136.jpg

Very nice.

Any chance more of these will get made?

Yes I do have more in the works. I'll check with my buddy and get an update.

Here is my finished sensor.
20150117_162702.jpg
20150117_162639.jpg
20150120_191217.jpg

Well played.

Are these still available?

x2!

I do have a few PM me a # and we can get arrangements made or meet up at ROX's in Nov.

PM sent

Any more of these available? Need one for my latest project.

Good deal, I'm in no hurry just wanted to make sure I wasn't out of luck.

Thanks again!