I need to do something about mine! I am tired of it rattling around behind the hole that was intended to be a glove box. Would LOVE to see what you guys have done and glean some ideas!

Thanks!

this box is out of an escape. easy to remove from the donor vehicle.

Hmm, and the computer slides on there? Looks like a nice piece!

The Escape box is what EFI Guy recommends. He helped me pull one for when I do my swap.

Sent from my HTC One using Tapatalk

Looking at google pics, looks like it's center of the cowl and comes out with two screws?



Sounds like some explorers have the same? Are there good model years to get these from?

Yup the escape box here also.

The Explorer boxes are easy. I pulled one in the yard in about 3 minutes last weekend. It was from a late 90s

JD, your Mustang harness is set up to put the PCM in the cab. So one that mounts it in the firewall isn't going to work for you. Also, I'm not sure how well an early EEC-IV PCM will fit in an EEC-V enclosure. They are similar in size but not exact. I would look for something from a PRE-96 ford car that was designed to mount it in the cab.

The Escape box in the diagram is a later PPC type (note the 3 connectors instead of 1) , those boxes are not a close match to the EEC computers at all. The Escape box to use with an Explorer swap will be PRE-2004 ish.

Justin, yours is an Escape box. The Explorer box is a nightmare to remove.

Ah, then thanks for the correction. (Applies palm to face)

I saw a post on FB, that BC Broncos had a computer mount that put it on the gas pedal bracket like the one I made.

This?
https://store.bcbroncos.com/products/ef ... ord-bronco

I wish the picture were better!