I'm trying to get my lower quarters installed. Currently working on the passenger but when I mocked up the drivers side, I'm seeing the same issue.

I have an ~1/4" gap at the top. I know on the passenger side, I had the issue where the spare tire carrier had pulled the top of the tail light housing apart. When I started, I had about a 3/8" gap. I've gotten it down to 3/16" at the top but right below the belt trim, is still 1/4".

Anyone have any ideas? Or is this just good enough and seam sealer is my friend? While this truck is far from perfect, I don't want to not fix something just due to laziness.

Pics:







It's currently all held in via friction and 2 screws. Once I can get it lined up, I'll drill more holes and start welding.

Thanks!

Adam