|
It is currently Thu Nov 21, 2024 10:11 am
|
|
Page 1 of 1
|
[ 10 posts ] |
|
Author |
Message |
Eck
Official CCB Member
Joined: Thu Oct 25, 2012 9:33 pm Posts: 2460
|
95 F150 A/C not working
I’ve checked fuses and they are good. Blower works but it blows hot air. Anyone know what steps to take to check for why the A/C doesn’t work?
Sent from my iPhone using Tapatalk
_________________ 69 Wagon, 351W, Explorer EFI & Serpentine, ZF5, 35" tires, 3.5 SL, 2 BL, WARN 8274
|
Fri Jun 08, 2018 1:31 pm |
|
|
TOOLMAN
Official CCB Member
Joined: Mon Feb 14, 2011 10:29 am Posts: 768 Location: The MHC
|
Re: 95 F150 A/C not working
No freon?
_________________ Wilma - 71 1/2 Wagon; 3 1/2" WH lift, 1" BL, NP435, Chebby disc front, WH twin stick D20, EFI 302, Cool hood scoop, mucho cancer; purchased in 1990.
|
Fri Jun 08, 2018 1:36 pm |
|
|
Viperwolf1
Official CCB Member
Joined: Tue May 07, 2013 10:37 pm Posts: 1485
|
Re: 95 F150 A/C not working
My guess is the compressor isn't turning. Could be clutch problem or no current to activate it. No current could be due to low pressure in the system. There is a pressure switch that will allow the compressor to run only if there is good pressure in the system. That switch could be bad or you may have a small leak.
|
Fri Jun 08, 2018 1:40 pm |
|
|
Eck
Official CCB Member
Joined: Thu Oct 25, 2012 9:33 pm Posts: 2460
|
Re: 95 F150 A/C not working
_________________ 69 Wagon, 351W, Explorer EFI & Serpentine, ZF5, 35" tires, 3.5 SL, 2 BL, WARN 8274
|
Fri Jun 08, 2018 1:45 pm |
|
|
horseplay
Official CCB Member
Joined: Mon Jan 21, 2013 8:24 pm Posts: 408 Location: Grand Junction CO
|
Re: 95 F150 A/C not working
hey Mike like they are saying you need to verify that you have a proper charge in the system a start working out from there.
|
Fri Jun 08, 2018 1:47 pm |
|
|
Viperwolf1
Official CCB Member
Joined: Tue May 07, 2013 10:37 pm Posts: 1485
|
Re: 95 F150 A/C not working
|
Fri Jun 08, 2018 1:53 pm |
|
|
Strike2
Joined: Mon Nov 28, 2016 11:34 am Posts: 808
|
Re: 95 F150 A/C not working
I've disconnected the lo pressure harness the turn the engine and a/c on and using a jumper wire (briefly) jumper the harness just to see if the compressor starts more than likely you have low Freon if the compressor starts. Good Luck Vipers way is probably more sensible (but then I would have to put my down to use a multimeter)
|
Fri Jun 08, 2018 1:54 pm |
|
|
Eck
Official CCB Member
Joined: Thu Oct 25, 2012 9:33 pm Posts: 2460
|
Re: 95 F150 A/C not working
Tried to jump the switch and I can’t tell if the compressor is kicking on. Air definitely wasn’t getting colder. My multi-meter is dead and I don’t have a battery for it so couldn’t check voltage to the switch.
Sent from my iPhone using Tapatalk
_________________ 69 Wagon, 351W, Explorer EFI & Serpentine, ZF5, 35" tires, 3.5 SL, 2 BL, WARN 8274
|
Fri Jun 08, 2018 2:19 pm |
|
|
TOOLMAN
Official CCB Member
Joined: Mon Feb 14, 2011 10:29 am Posts: 768 Location: The MHC
|
Re: 95 F150 A/C not working
_________________ Wilma - 71 1/2 Wagon; 3 1/2" WH lift, 1" BL, NP435, Chebby disc front, WH twin stick D20, EFI 302, Cool hood scoop, mucho cancer; purchased in 1990.
|
Fri Jun 08, 2018 2:47 pm |
|
|
Digger
Official CCB Member
Joined: Fri Jun 21, 2013 8:53 pm Posts: 1276
|
Re: 95 F150 A/C not working
You can see whether it is turning or not. The inside of the pulley does not rotate when A/C is not cycling.
Center of pulley should cycle on and off with A/C on.
I would guess you have a leak and have lost enough freon that the low pressure switch will not let the comp engage.
_________________ Cummins R2.8 diesel, ZF5, AtlasII, HP44/BB9, ARBs, coiled / linked suspension, 37" KO2s, full cage, bumpers, etc. Build Thread:
Average 23.5 mpg, Best tank: 25.1 mpg
|
Sat Jun 09, 2018 8:07 pm |
|
|
|
|
Page 1 of 1
|
[ 10 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 0 guests |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|