|
It is currently Thu Nov 21, 2024 10:59 am |
|
All times are UTC - 7 hours [ DST ] |
|
Page 1 of 1 |
[ 6 posts ] |
| Previous topic | Next topic |
WTB medium duty lg bearing housing (EB width)
| Author | Message |
|---|---|
|
Joined: Mon Nov 23, 2015 9:29 pm Posts: 16 Location: Conifer 
|
 WTB medium duty lg bearing housing (EB width)Should correspond to MY 1974 and 1975 as far as I know. 10" brakes / 3/8in bolt holes in flanges / "torino" end pattern I believe
Planning to build a new rearend this winter. Expect to buy a fresh housing from a vendor but figured might as well at least try to find a used one first. Last edited by OldBalls on Tue Jun 23, 2020 12:59 pm, edited 1 time in total. |
| Mon Jun 22, 2020 6:03 pm |
|
|
|
|
Official CCB Member   Joined: Tue May 07, 2013 10:37 pm Posts: 1485
|
Re: WTB medium bearing housing (EB width) Medium duty with big bearings and 10" brakes?
|
| Mon Jun 22, 2020 9:06 pm |
|
|
|
|
Official CCB Member Joined: Sun Jul 07, 2013 6:06 pm Posts: 639 Location: Falcon, CO
|
Re: WTB medium bearing housing (EB width) I have a '74-75 early Bronco housing and a new Yukon 31 spline axle shaft kit I have been trying to sell. The housing has been hot tanked to get all the grease off. This is the kit I have: https://www.randysworldwide.com/product ... onco-4-31/
You do not have the required permissions to view the files attached to this post. _________________ 1969 Bronco: Full widths, 3 linked front end, 37's, hydro-boost, 4x4x2 box, ZF5, Atlas t-case, and fuel injected 302 |
| Mon Jun 22, 2020 10:31 pm |
|
|
|
|
Joined: Mon Nov 23, 2015 9:29 pm Posts: 16 Location: Conifer
|
Re: WTB medium bearing housing (EB width) Yes that's correct medium duty big bearing 10" brakes 3/8" bolt holes on flanges. I'll see if I can edit the post to clarify.
Will PM about the housing. As it happens I already have that same axleshaft kit. Thx guys. |
| Tue Jun 23, 2020 10:32 am |
|
|
|
|
Joined: Mon Nov 23, 2015 9:29 pm Posts: 16 Location: Conifer
|
Re: WTB medium duty lg bearing housing (EB width) Looks like the housing is sourced. Thanks Phil!
|
| Tue Jun 23, 2020 6:33 pm |
|
|
|
|
Joined: Mon Nov 23, 2015 9:29 pm Posts: 16 Location: Conifer
|
WTB 4.88 gear set 9" Looking for quality parts in decent shape... plan to drive this truck a lot
|
| Thu Jun 25, 2020 10:40 am |
|
|
|
|
|
Page 1 of 1 |
[ 6 posts ] |
|
All times are UTC - 7 hours [ DST ] |
Who is online |
Users browsing this forum: No registered users and 9 guests |
| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum |